Author Archives: Brian

CutterPros Walk-In Customer Policy

Valued Customers, As CutterPros has grown over the past 5 years we have experienced an exponential increase in our local walk-in traffic. First, we would like to thank you all for allowing us to serve your needs. Second, we would … Continue reading

Posted in Uncategorized | Leave a comment

Customer Memo 01/13/2017

Valued Customers, We would like to take the opportunity to announce some new products we have added to the web site. As many of you are aware, we have expanded the 12″ and 15″ desktop cutters with Saga with 9 … Continue reading

Posted in Newsletters | Leave a comment

True Size Scaling in DragonCut

1) Open DragonCut 2) Go to “Tools” on the top menu, select “Plugins & Modules”, select “Vinyl Spooler…” 3) In the Vinyl Spooler, select “Cutter” from the top menu bar, select “Configure Cutter” 4) Select “Units” on the left side … Continue reading

Posted in DragonCut, Saga, Vinyl Cutting Tutorials Tips And Tricks | Leave a comment

Vinyl Cutting Rubber Sand Mask Or Paint Mask

For best results when cutting rubber mask with a vinyl cutter, follow these guidelines: 1) Make sure the cutter is cutting the rubbery side of the material. One side is shiny and slippery, one side is dull and rubbery. Always … Continue reading

Posted in Saga, Vinyl Cutting Tutorials Tips And Tricks | Leave a comment

Preparing Boat Surfaces For Application Of Vinyl

The first step for preparing boat surfaces for the application of vinyl is cleaning. IPA (isopropyl alcohol) is generally recommended unless the substrate manufacturer states that there is an incompatibility. Caution: many cleaning agents can leave a residue that either … Continue reading

Posted in Uncategorized | Leave a comment

Changing The Carriage On A Saga Standard Stepper Or Servo Vinyl Cutter

1) Remove plug from vinyl cutter (Always the first step when servicing your cutter) 2) Remove endcaps (four screws on inside plates) 3) Remove the top cover plate (carefully so you don’t pinch the wires on the right side). It … Continue reading

Posted in Cutter Maintenance, Saga | Tagged , , , , | Leave a comment

Creation CR630 / CR1200 Vinyl Cutter Setup

The Creation CR630 and CR1200 vinyl cutters are very similar. The CR630 is a 24″ cutter while the CR1200 is a 48″ cutter. Aside from the difference in length, the CR1200 also has an extra stepper motor to drive the … Continue reading

Posted in SignCut, Vinyl Cutting Tutorials Tips And Tricks | Tagged , , , | Leave a comment

CutterPros Newsletter Volume 2

The big news this month is our participation at the Shanghai show in the Saga booth. Pictures are posted on the Saga blog site. Saga and Future Corporation (makers of DragonCut) have been working very hard on the newest version … Continue reading

Posted in Uncategorized | Leave a comment

First CutterPros Customer Communication

Historically, CutterPros has not sent out very many customer communication emails. We are looking to change this and to attempt to send out informational emails once a month with company updates to stay in touch with our customers. We have … Continue reading

Posted in Uncategorized | Leave a comment

Contour Cutter Laser Calibration Using Flexi Starter

An easy way to calibrate the offset coefficients for your cutter is to use the cutter laser to self-measure the distance from a contour loop to a geometry loop. Following is the procedure: Do not remove the paper from the … Continue reading

Posted in Flexi, Vinyl Cutting Tutorials Tips And Tricks | Leave a comment